RITE-HITE ELIMINATOR II 610 Series, Инструкция по установке и руководство пользователя

Страница: 35 / 40

C O L L A P S I B L E S T Y L E
D R A F T PA D
Pub. 41090004 Rev. 3 - JUNE 2014
K1
Figure 1
Table of Contents
EGM draft pad pre-assembly. . . . . . . . . . . . . . . . . . . 1
EGM draft pad installation . . . . . . . . . . . . . . . . . . . . . 2
File Information
Document Name: 41090004
Date Last Revised: 06/30/2014
Revision: 3
General Precautions
Introduction
The following installation instructions are complete for
all applications of the Collapsible Style Draft Pad that
are normally available. Any application of the
Collapsible Style Draft Pad that is outside of normal
application guidelines, should be referred to Order
Engineering for installation instructions. These
instructions also assume that the installer is outside
the building facing the loading dock position.
Illustrations
Illustrations for this document are contained on
drawing # 4109-0005
Installation
Retrofit panel installation:
If velcro attachment flap is not located on side pad
cover, the use of a retrofit panel is required.
Install retrofit panel as shown in Figure 1. Rear edge
should be screwed to side pad backer in 3 places.
Front edge should be located between side pad cover
and side curtain attachment flap.
WARNING
Post safety warning and
barricade work area, at dock level
and ground level to prevent
unauthorized use of the dock
position while service work is
being performed.