RITE-HITE ELIMINATOR II 610 Series, Инструкция по установке и руководство пользователя

Страница: 10 / 40

610 SERIES SIDE FRAME
D3
Pub. 56560007 Rev. 4 - JUNE 2014
Instructions
“Common Member”
This section of these installation instructions details
how “common member” side frames are installed.
1. Follow steps 1 - 4 from the standard installation
procedure for the side frame that are not common
with another unit. (See Figure 5)
2. Follow step 1 from the standard installation
procedure for the side frame that is common except
install the common member header mounting
bracket. (See Figure 4) Install screws on both sides
of the frame.
3. Common member side frames will follow the same
procedure as standard side frames, except that the
side frame is centered on the unit width mark that
was made on the wall. (See Figure 5)
4. See “Bracketing Details” section of these
installation instructions for details on how to install
the brackets that will be shipped with the side
frames.
5. Attach the side frames to the building wall.
Note: Take special care with common member
side frames. Too much variances in mounting
distances between header mounting brackets
will cause installation problems with common
member units. Read canopy style header
installation instructions for common member
units before proceeding.
Refer to “Fastening Methods” section of these
instructions for the correct fastening method for the
building style the side frames are being installed on.
4" Side Frame Widths
(40" or Less Projection)
These instructions list how to install a set of 4" side
frames that are on a stand alone unit and < 40" in
projection.
1. Reference the standard installation instructions
1531-0002 and 1321-0008 (blockout applications)
along with these instructions before proceding.
2. After Step 7 in 5656-0007 installation instructions,
install the bumper provided as instructed in the
bumper installation instructions 1531-0002. These
bumpers must be installed.
3. Always install the side member in it's correction
location and mount the bumper relative to the side
member. Never install or adjust side member to
bumper location. This bumper is required for the
protection of the side member from being
compressed completely to building wall.
(Warning: Failure in not to install the bumpers
and/or incorrectly installing of the bumpers
could result in damage and/or failure of the unit.
Always follow standard bumper fastening
methods as described per each individual
bumper models.)
4" Side Frame Widths
(Greater than 40" Projection)
These instructions list how to install a set of 4" side
frames that are on a stand alone unit and > 40" in
projection.
1. Follow the standard installaion instructions for the 4"
side frames.
2. Securely attach the side frame blockout at the further
most point out from the building wall to either the
bumpers, the building foundation, overhang, or any
other appropriate rigid structure undersneath the
side frames. This is required to stabilize the side
frames while in use.
(Warning: Failure to attach blockouts to the
bumpers will result in damage and/or failure of
the unit.)
FIGURE 4
−