RITE-HITE ELIMINATOR II 610 Series, Инструкция по установке и руководство пользователя

Страница: 13 / 40

Pub. 28600003 Rev. 1 - JUNE 2014
E1
6 1 0 S E R I E S S I D E C U R T A I N
Table of Contents
File Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E1
General Precautions . . . . . . . . . . . . . . . . . . . . . . . . .E1
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E1
Illustrations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .E1
Installation Instructions . . . . . . . . . . . . . . . . . . . . . . .E1
Standard Eliminator TM II . . . . . . . . . . . . . . . . . . . .E1
Common Member Eliminator TM II . . . . . . . . . . . . .E2
Standard Eliminator TM -Gapmaster TM II . . . . . . . . . .E2
File Information
Document Name: 28600003
Date Last Revised: 06/30/2014
Revision: 1
General Precautions
Introduction
The following installation instructions are complete
for all applications of the side frames that are normally
available. Any application of the side frame that is
outside of normal application guidelines, should be
referred to Order Engineering for installation
instructions. These instructions also assume that the
installer is outside the building facing the loading dock
position
Illustrations
Illustrations for this document are contained on drawing
#2860-0004
Installation
Standard Eliminator
TM
II
These instructions illustrate how to install a pair of
Eliminator™ II Side Curtains that are on a stand alone
Unit.
1.
Align top edge of side curtain to top edge of side
frame at the same time aligning the velcro flap on
the outside of the side curtain to the velcro on the
outside of the side frame. (See Figure 1)
2. Make sure that the velcro flap on the outside of the
side curtain completely covers the velcro on the
side frame. (See Figure 2)
3. Continue to align the velcro flap to the outside of the
side frame velcro at the top, and continue working
downward to the bottom of the side frame. Keep
continuous downward pressure on side curtain to
avoid wrinkles in fabric.
4. Starting at the top, repeat Steps 1 & 2, to the inside
velcro flap on the side curtain. However, due to
variations, the velcro flap on the side curtain may
not always cover the velcro on the inside face of the
side perfectly. It is important to make sure the side
curtain is perpendicular to the side frame when
finished.
(Note: Always align outside velcro flap
first.)
FIGURE 1
WARNING
Post safety warning and
barricade work area, at dock level
and ground level to prevent
unauthorized use of the dock
position while service work is
being performed.