Risco gt490x, Инструкция пользователя

Страница: 29 / 40

Page
27
GT490X
User Manual
G-Tag Introduction
G-Tag is a method of Setting and Unsetting your security system via a Proximity
Reader and a Tag. The Proximity Reader may be an internal reader that is fitted on to
the inside of a doorframe etc or an external reader that is fitted into the doorframe on
the outside of the premises.
Legislation contained within BS8243 does not allow for the
transmission of confirmed alarm signals once the entry time has
started if the user of the security system is using a manual code
entered into the keypad. G-Tag conforms fully with the
requirements of this legislation relating to confirmed alarms on
entry.
Because the G-Tag uses Proximity Technology there are no batteries to change in the
unit, it is small enough to be carried on the users key ring and one Tag may be used
on multiple security systems and some door entry systems.
Programming G-Tag Tags Onto Your System
Programming The Tags onto your system is very simple. Follow the instructions for
programming User Codes onto your system up to the point when you would enter the
User Code. At this point present you Tag to the Proximity Reader and a code will be
entered for you. Continue with the instructions entering the User Name etc. Each G-
Tag will be identified on an individual basis when it is used to Set or Unset the system.
4 Wire Keypad
Each G-Tag need only to be programmed onto one of the 4 wire keypads in multiple
reader installations.
Using G-Tag On Your System
G-Tag is a method of entering a code into your security system.
To Set Your System Using G-Tag
When you wish to Set your system simply present your Tag to the Proximity Reader
and exit the protected area following the normal Setting You System Instructions.
To Part 1 Set Your System Using G-Tag
If using G-Tag Part 2 and Part 3 Setting will not be available (a manual code should be
used to Part 2 or 3 Set the system).
To Part 1 Set your security system press YES twice
the display will show:-
Present your Tag to the Proximity Reader and exit the
protected area following the normal Part Setting You System Instructions.
G-Tag Fob
Press . .
CODE to Part - Set
PR5847 Rev11 490X User Guide.qxd 10/05/2012 11:01 Page 27