Page
30
GT490X
User Manual
5)
Exit the premises via the authorised exit route.
6)
Once the premises are secure listen (from outside
the protected area) and wait until the exit tone finishes before leaving.
Re-setting the display after a Mains Fail
Note:
In the event of a Mains Power Failure, the control panel will display that a fault has occurred if the
pre-programmed time has been exceeded.
1)
In the event of a mains power failure the display
will show:-
2)
Enter your
User
code. The display will show:-
The right arrow is now indicating that more events are available for viewing.
Press the YES key to view the next event and carry on to view any others.
When viewing the last event the display will show,
for example.
The left arrow now indicates that you are at the end of events.The NO key
may be used to scroll back the opposite way.
3)
Enter your
User
code again.The display will then
show:-
(Followed by YES if a
Master
or
Main
type code
has been used).
4)
Enter the code again to abort the setting or press
the
Reset
key. The display will show:-
The system is now reset.
! !
Enter Code ! !
! ! ! ! Check ! ! ! !
Power Cut FAULT
01 JAN 18 : 58 : 01->
Mains Ok Ack
01 JAN 18 : 58 : 01<-
EXIT!
All Zones ON 15
Time will count down
01 JAN 18 : 58 : 01
PR5847 Rev11 490X User Guide.qxd 10/05/2012 11:01 Page 30
Содержание gt490x
Страница 2: ......
Страница 35: ...Page 33 GT490X User Manual Notes ...
Страница 36: ...Page 34 GT490X User Manual Notes ...
