STEP 5
Cut away the covering over the servo lead holes in the underside of the wing panels and carefully
pull the leads through to the center of the wing using the cotton thread.lift out the servo connector
through the hole then retain the servo lead with a short length of tape to stop the lead pulling back
into the wing.
STEP 6
Check that your choice of servo fits the servo apertures in the underside of the wing. Adjust the
size of the mounting holes with a sharp knife if required. Pilot drill the mounting holes.
STEP 7
Screw the aileron servos in position using the mounting screws, rubber grommets and ferrules
supplied with your radio. Note that the output arms face towards the rear of the wing.
