Rinnai
9
Operation Manual
BASIC HEATER OPERATION
FLAME FUNCTION
The flame function is used to select a desired flame picture and overrides the
automatic mode. There are seven separate flame picture settings available.
While the heater is in operation press the Flame
button once to activate
this function. The heater will automatically default to the last used flame
picture setting. "Flame" and a series of seven short bars
(one bar for each
of the seven flame picture settings) will be displayed to show that the flame
function is in operation.
Use the Up and Down
buttons to select the desired flame picture. The
number of bars illuminated correspond to the flame picture setting selected.
To return to automatic mode press the Flame
button a second time.
Should the room temperature reach 40°C whilst the flame
function is activated the heater will switch off automatically.
This is a safety feature.
REMOTE CONTROL BATTERIES
Use 2 x 1.5V AAA batteries. NEVER mix old and new batteries.
Remove batteries if the remote control is not going to be used for a long
period. This will help avoid damage from leaking batteries.
To replace batteries simply unscrew the battery compartment cover located
on the back of the remote control anti-clockwise. When installing new batteries
ensure that the correct polarity is observed, the polarity is engraved into the
battery compartment. See the illustration on page 3.
13
31
12
13
Temperature
Lock
AM
PM
Timer 1 Set
ON OFF
ON OFF
Timer 2 Set
Override Auto Off
Time
Flame
31
STANDBY
ON
Flame
Extra
Low
Lock
Timer 2
Timer 1
Overide
Time
Set
Temperature
Lock
Clock
AM
PM
Timer 1
Set
Set
ON OFF
ON OFF
Timer 2 Set
OverrideAuto Off
Time
Flame
20
21
14
15
16
17
19
18
11
13
12
NOTE
