Rinnai REU-VR2632FFUD - 26i, Инструкция по установке и эксплуатации

Страница: 32 / 64

32
EZ CONNECT
EZ Connect Installation
The EZ Connect allows the installation of two water heaters to be
controlled by one remote controller without PAM valves or a MECS. The
EZ Connect will sequence the heaters for low flows and rotate the lead
heater for even use.
Installing the EZ Connect
1. Install the two water heaters from 50mm to 450mm apart so that the EZ Connect cable will reach
between the two.
More than 450mm apart can cause temperature fluctuations.
2. Remove the protective cap from the 3 pin connector marked EZ Connect located in the wiring
harness of the Primary Unit. (Fig. 1)
3. Plug in the EZ Connect cable. The end marked “To EZ Connect” connects in the primary water
heater to the 3 pin connector seen in Fig. 2. The other end, marked “To PCB”, connects to the
empty plug at the top of the PCB of the other water heater (sub unit.). (Fig. 2 and 3)
4. Securely fasten the EZ Connect cable to the bottom of each water heater with the cable clamps
and screws supplied. (Fig. 4)
•
The EZ Connect cannot be used with the
MECS.
•
The EZ Connect cannot use the Bath Fill
Function
•
The temperature can only be changed on the
primary unit’s controller.
•
PAM valves are not required.
NEW FEATURE
50 -
450mm
Fig.1
Fig.2
Fig.3
NOTE
Fig. 4