Rinnai REU-VR2632FFUD - 26i, Инструкция по установке и эксплуатации

Страница: 28 / 64

28
For the Internal range the flue system is considered part of the continuous flow water heater. The follow-
ing flue type and make is approved in combination with above mentioned water heaters. Separate in-
structions are provided with the flue detailing the installation of the flue parts.
Ubbink
flue system for HD70i:
952-032-001 HD70i standard horizontal kit
952-032-002 HD70i 45° bend
952-032-003 HD70i 90° bend
952-032-006 HD70i flue extension L=1m
952-032-007 HD70i vertical flue kit
952-032-008 HD70i flat roof flashing 150Ø
952-032-011 HD70i lead tile 25°-45° roof
952-032-017 HD70i lead tile 5°-25° roof
952-032-022 HD70i horizontal extension kit
The first flue component on the heater must be a special vertical female/female discharge adaptor. The
centre, exhaust adapter has integrated condensate trap, but the air intake does not. For terminations
straight through the wall the special horizontal adapter for short flue lengths is used. Never use an ex-
tension as the first component, they will cause damage to the water heater and the flue system. Secure
flue connections with pipe clamps or perforated hanger iron. Please see
page 29 for recommended ter-
minal positions.
Ubbink
flue system for 26i / HD50i:
FLUE REQUIREMENTS
26i/HD50i Standard Horizontal Kit
Ø80 -125mm
26i/HD50i 90˚ Bend
Ø80 -125mm
26i/HD50i Vertical Flue Kit
Ø80 -125mm
26i / HD50i Extension
1m x Ø80 -125mm
26i/HD50i Lead Tile
25˚ - 45˚ Roof
Warning: Before installation inspect each flue component for damage and
correct seal placement. Do not attempt to fix or install any damaged compo-
nent. Improper installation of flue systems or components, or failure to fol-
low all installation instructions can result in property damage or serious in-
jury.