Page 38
2.When connecting the power cords to the terminal block,make sure that the wire and
the electric conductor inside the terminal block are in full contact. Then tighten the
screws. If it is loose, May causing electrical short circuit and/or the terminal block burn
out.
ELECTRICAL INSTALLATION
3. Again make sure that the wiring from the main circuit breaker to the water heater is
correct. If the wrong wires is connected, the product will not work normally and may
cause unnecessary danger.
4. Check earth resistance and make sure there is a proper earth continuity.
5. Confirm that all the air has been purged from the water lines prior to turning on power
to the unit.
Содержание EI06
