Diagnostic Tests for the Rimage Professional™ 3400 and 5400N
2
2001497_A
Exit Diagnostic Test Mode
1.
If a diagnostic test is currently in process, press
button 1
once to stop the test.
2.
When the diagnostic test is stopped, press
button 1
eight times and hold it in until the operator panel
displays
[99 EXITING DIAGNOSTIC]
.
3.
Release
button 1
. The autoloader exits diagnostic mode.
Note:
At the end of diagnostic test 3, the autoloader automatically exits the test and returns to diagnostic
test mode.
Perform Diagnostic Tests
Test 1 – Solenoid Test Diagnostic
This test cycles the solenoid in the lift arm.
1.
Make sure the autoloader is in diagnostic test mode. Refer to the
Access and Select Diagnostic Tests
section on page 1.
2.
Press and hold
button 1
until the operator panel displays
[01 SOLENOID TEST CYCLE = XXXXXX]
, where X
is the number of solenoid cycles completed.
3.
Release
button 1
. The test starts automatically.
•
The autoloader begins to cycle the solenoid in the lift arm.
•
The cycle count advances on the operator panel.
Note:
The autoloader continues to cycle the solenoid until you press button 1 to stop the test.
4.
Press
button 1
once to stop the test and return to diagnostic test mode. The operator panel displays
[00
CHOOSE DIAGNOSTIC]
.
