13
2001475_A
Operate the Producer III
Install the Carousel
Tip:
To prevent errors, install the carousel before operating the software or powering on the autoloader.
1.
Open the
front door
.
2.
Install the
carousel
in the Producer III.
a.
Slide the
carousel
straight in so that the center post slides through the slot opening of the bearing guide.
b.
Rotate the
carousel
until the top support bearing lowers into the bearing guide.
3.
Close the
front door
.
Remove the Carousel
Remove the carousel from the autoloader to load or unload discs.
-
Important!
If the Rimage software is currently running an operation on the autoloader, wait for the software to
complete the operation, or pause the software operation before removing the carousel.
1.
Open the
front door
.
2.
Grasp the bottom of the
carousel
with two hands.
3.
Lift the
carousel
off the carousel platter until the top support bearing clears the bearing guide.
4.
Move the
carousel
out of the autoloader.
Center Post
Bearing Guide
Top Support Bearing
En
gli
sh
Содержание Producer III 6100
