SAFETY INSTRUCTIONS
EXTENSION CORDS
Keep the extension cord
clear of the working area. Position the cord
so that it will not get caught on lumber, tools
or other obstructions while you are working
with a power tool.
Check extension cords
before each use. If damaged replace im-
mediately. Never use a tool with a damaged
cord, since touching the damaged area could
cause electrical shock, resulting in serious
injury.
Use a proper extension cord. Only use cords
listed by Underwriters Laboratories (UL). Other
extension cords can cause a drop in line voltage,
resulting in a loss of power and overheating of
tool. When operating a power tool outdoors, use
an outdoor extension cord marked “W-A” or “W”.
These cords are rated for outdoor use and reduce
the risk of electric shock.
Page 7
SPECIFICATIONS
MOTOR POWER ............. 1/2HP, 120V, 2.5A, 60Hz, 1Ph, Induction
MOTOR RPM (no load) ................................................... 1750 RPM
RECOMMENDED RUN TIME ......................................... 30 Minutes
MOTOR ARBOR ........................................................ 17mm (11/16”)
ARBOR THREADING ............................................ M16LH / M16RH
BUFFING WHEEL SIZE ..................... 8” Dia. x 1/2” Wide, 5/8” Bore
MAX. BUFFING WHEEL WIDTH ............................................ 1-3/8”
BUFFING WHEEL SPEED .............................................. 1750 RPM
ROTATION (Viewed from left side) ................................... Clockwise
ON/OFF SWITCH ....................................... Toggle and Safety Lock
POWER CORD ........................................................ 18AWG, 6 Feet
GRINDER BASE (LxW) ............................................. 8-3/4” x 7-3/4”
MOUNTING HOLES (2) ............................... 7/16” Dia., 7-3/4” Apart
OVERALL SIZE Approx. (LxWxH) ...............22-1/2” x 7-3/4” x 9-1/2”
NET WEIGHT ......................................................................... 23 lbs.
SHIPPING WEIGHT ............................................................... 26 lbs.
NOTE:
The specifications, photographs, drawings and information in this manual represent the
current buffer model when the manual was prepared. Changes and improvements may be made at
any time, with no obligation on the part of Rikon Power Tools to modify previously delivered units.
Reasonable care has been taken to ensure that the information in this manual is correct, to provide
you with the guidelines for the proper safety, assembly and operation of this machine.
