ASSEMBLY
Page 10
THE MACHINE MUST NOT BE PLUGGED IN
AND THE POWER SWITCH MUST BE IN THE OFF POSITION UNTIL
ASSEMBLY OF THE PARTS AND ALL ADJUSTMENTS ARE COMPLETE.
MOUNTING THE DISC TABLE & DISC COVER
The larger worktable is used with the sanding disc. It should be used to support
workpieces in all sanding operations except inside curve sanding applications.
1. Loosen the inner hex screw (A) using the supplied 5 mm hex key, and raise the
belt bed (B) in the vertical position. Tighten the inner hex screw (A).
2. Place the smaller worktable (C) onto the belt sander frame, aligning the semi-
circular slot (D) with the threaded hole (E) in the sander’s frame.
3. Place the washer (F) on the shaft of worktable locking lever (G), insert through the
table’s semi-circular slot (D), and tighten the lever in the threaded hole (E).
4. Adjust worktable to level or any angle between 0° and 45° for sanding.
1. Locate the two worktable locking lever
handles (A) and washers (B) in parts bag.
2. Place the worktable (C) onto the sander
frame, aligning the semi-circle slots (D)
with the threaded holes (E).
3. Place a washer (B) on the threaded
shafts of each worktable handle (A), insert
the handle shafts through the semi-circu-
lar slots (D), and tighten into the threaded
holes (E) on both sides of the table.
4. Adjust the worktable to level or any
angle between 0° and 45° for sanding.
5. Lock the table in place with the handles.
B
A
D
C
E
B
A
To avoid jamming the workpiece or fingers between the table
and sanding surface, the tables’ edge should set 1/16” away from the sanding
surface. The tables’ distance to the disc or belt can be adjusted by loosening the
bolts that secure the table bracket(s) to the table. Loosen the bolts, adjust the
table location, then tighten the bolts to secure the table in place.
MOUNTING THE BELT TABLE
Mounting the smaller worktable for use with the sanding belt follows the same
instructions as above, but only one table bracket is used on this table.
See Figures 4 and 5 on page 11.
FIG. 3
CONTINUED ON PAGE 11
6. Mount the Sanding Disc Safety Cover (F) onto the metal frame that surrounds
the sanding disc with the two Phillips Screws (G) supplied in the parts bag.
7. The cover guards the left, upward rotation side of the sanding disc to prevent any
accidents from occurring. Always sand on the downward, right side of the rotating disc.
G
F
