Rikon Power Tools 10-347, Руководство оператора

Страница: 17 / 40

17
ADJUSTMENTS
Figure 29
Figure 28
Figure 27
ADJUSTING THE FENCE TO THE TABLE
Check that the fence is lying flat, or parallel to the
table surface. The gap between the table and the
bottom of the fence should be equal along the whole
length of the fence. If a slight adjustment is necessary,
the Nylon Plate (#25F), that is located at the front
base of the Fence Carrier (#9F), can be turned to
raise or lower the fence distance over the table. Fig.
27.
If there is a sizeable gap, refer to page 11 for the
mounting and re-positioning of the front fence rail.
ADJUSTING THE FENCE ON THE CARRIER
The fence can be changed from a vertical position to
a horizontal position, or from its mounting on the left
side of the blade to the right with simple adjustments
of the carrier’s handles and hardware.
To change the fence from vertical to horizontal:
1. Loosen the side Handle (#7F, Fig. 28, A) which
holds the rip fence again the Fence Carrier (#9F, B).
2. Slide the fence forward to remove it from the
carrier’s Sliding Block (#11F, Fig. 28, C).
3. Turn the fence down to its horizontal position and
slide it back onto the carrier. The bottom of the fence
is slotted to mount on the sliding block, and position
itself on the small, raised key (Fig. 28, D) on the side
of the carrier. Fig. 29.
4. Once in place, retighten the side handle to secure
the fence in position on the carrier.
5. Check the fence for drift, and make corrections if
needed per instructions on page 16.
To change the fence from the left side of the
carrier to the right side for using the rip fence to
the right of the blade:
1. Loosen the side Handle (#7F, Fig. 28, A) which
holds the rip fence again the Fence Carrier (#9F, B).
2. Slide the fence forward to remove it from the
carrier’s Sliding Block (#11F, C). Move the carrier on
the front rail to the right side of the table and blade.
3. Fully unscrew the side handle from the sliding
block and reassemble the parts on the opposite, left
Figure 30
CONTINUED ON PAGE 18
B
A
C
SIDE HANDLE AND SLIDING BLOCK
MOVED TO OPPOSITE SIDES
ON CARRIER
D