Rikon Power Tools 10-347, Руководство оператора

Страница: 25 / 40

25
TROUBLESHOOTING
If a blade is tracking on the rear of the lower wheel, away from the door, follow these steps:
1.) De-tension the saw blade.
2.) Loosen 9 o’clock shaft bolt to take pressure off the shaft.
3.) Loosen 6 o’clock shaft bolt one half rotation.
4.) Tighten the 12 o’clock shaft bolt until the shaft touches the 6 o’clock adjusting bolt.
5.) Lock all three shaft bolts.
6.) Re-tension the saw blade and set the upper wheel to plumb by adjusting the tracking
knob. Spin the upper wheel by hand and track the blade.
7.) Repeat if further adjustment is necessary.
1.) De-tension the saw blade.
2.) Loosen 6 o’clock shaft bolt to take pressure
off of the shaft.
3.) Loosen 9 o’clock shaft bolt one half rotation.
4.) Tighten the 3 o’clock shaft bolt until the shaft
touches the 9 o’clock adjusting bolt.
5.) Lock all three shaft bolts.
6.) Re-tension the saw blade and set the upper wheel to plumb by adjusting the tracking knob.
Spin the upper wheel by hand and track the blade.
7.) Start the bandsaw and check blade movement.
8.) If movement has diminished then continue with the adjustment.
9.) If movement is worse, reverse the adjustments in steps 3 and 4.
Back and forth
movement.
Correct
Incorrect
If a blade is moving back and forth (wobbling) follow
these steps:
First, check the bandsaw blade to insure that it has been
welded correctly, so that the blade’s back is in proper
alignment - flat (if it is laid down on a table surface).
If the blade is welded true, then adjustment to the wheel
hub on the rear of the bandsaw is required.