RIHO Whirlpool 10, Инструкция по установке и эксплуатации

Страница: 28 / 76

EN
IW00372. 3 EN
All Riho baths are made of acrylic (polymethyl methacrylic) and supported in the bottom with chipboard and reinforced
with glass fibre polyester.
Acrylic is a plastic and coloured all the way through. The properties of acrylic provide the user with the maximum
bathing comfort, provided the appropriate installation and maintenance instructions are duly followed.
2.0 Riho acryl (PMMA) tubs (Whirlpools)
4.0 Operation
4.1 Electronic Controls.
Before using the whirlpool installation, fill the bath up to 5 cm above the highest jet (hydro system) and to about 15 cm
under the rim (aero system).
Do NOT touch, handle or use electrical appliances when using the whirlpool. This is highly dangerous.
4.1.1 Modes.
Standby:
When the system is in standby mode the icons will not light up.
1.5.6 Electrical connection
The electrical supply for the installation must be provided with suitable cable and the connection has to be made in a
waterproof box. The whirlpool is delivered with a 3x2.5mm² or 5x2.5mm² cable (5x2.5mm² in case of whirlpool with two
hydromotors). The whirlpool bath must be connected with cable 3x2.5mm² 230V / 50Hz (if delivered with a 3x2.5mm²
cable). In the case of whirlpool is delivered with a 5x2.5mm² cable, it is necessary to use 2 phases. The connection must be
made with a cable 5x2.5mm² 400V / 50Hz (2 phases, 2 neutral, 1 ground) or two cables 3x2.5mm² 230V / 50Hz. Each cable
has to be protected by the appropriate circuit breaker 16A with characteristic C and earth leakage circuit breaker up to
30mA. It is necessary to ensure disconnection of all poles in the fixed supply line. The disconnecting element must have
contact distances so as to ensure that all poles are completely disconnected at Category III overvoltage (e.g. switch with
status indication). Please observe local laws and regulations regarding electrical connections. In case of doubt, consult a
plumbing specialist or contact one of the RIHO assembly or service centres.
1.5.7 Potential difference equaliser
T he installation must be supplemented by a separate additional connection wire, which must be led out of the main
potential interconnection of the building or from the switchboard from which the connection for the whirlpool is taken. This
wire must have a solid core with a minimum cross-section of 4-6mm2 and its insulation must be in green-yellow
combination.
3.0 Maintenance
-8-