RIHO Whirlpool 10, Инструкция по установке и эксплуатации

Страница: 29 / 76

EN
EN
Whirlpool 10 Button - User Manual
Power on:
Touch the " "button on the control panel to turn on the system. The display will now show the current
temperature. If there is no operation within 30 seconds after turning on the system or when the " "button is
touched and held for 2seconds, all buttons will be locked except the " "button. Touch the " "button to unlock
the system.
Power off:
When the system is on, shortly press the " "button to turn off the system. If there is no operation after the system
is turned on, the system will automatically turn off after 30 minutes. If you do touch any button the system will function
for 30 minutes from the moment the last button was touched.
Safety lock:
When touching the " "button for two seconds the lock function is turned on. All buttons are deactivated untill the
system is unlocked. This can be done by shortly touching the " "button.
4.1.2 Aero function.
Touch the " "button on the control panel to power on/off the aero function. When the bath is filled (waterlevel is
sufficient), the aero pump will start working and the " "button will light up (not dimmed). The aero pump will start
at its maximum speed (level 5). When the bath is filled (waterlevel is sufficient) and you touch the " "button the
speed will turn up one level at the time. After level 5 it returns to level 1 then 2, 3, 4 and then back to 5. When the bath
is empty (waterlevel is not sufficient), the aero function will not work. When this button is not touched for 5 seconds,
the system will exit the aero speedsetting mode. The LCD screen shows "Lx" (x is speed level) as fig 8 shows:
4.1.3 Hydro function.
Touch the " "button on the control panel to power on/off the hydro function. When the bath is full (waterlevel is
sufficient), the hydro pump will start working and the " "button will light up (not dimmed). When the bath is empty
(waterlevel is not sufficient), the hydro function will not work and the backlight will stay in a dimmed state. This also
happens when the hydro function is on and the water level drops under the minimum level. The hydro function will
then stop and the backlight will return to a dimmed state.
4.1.4 Colour therapy.
Touch the " "button on the control panel to turn on/off the chroma light. The chroma light will change colour
automatically once activated and the backlight of the button repeatedly turn on/off at this time. When you reach your
preffered colour you can lock it by touch and holding the " "button for 2 seconds. The backlight of the button will
be on in this mode (not dimmed). To resume the colour loop touch and hold the " "button for 2 seconds again.
The backlight of the button will again fade in and out repeatedly.
Figure 7
On / Off
Aero
Aero Levels
Settings / Menu
Minus / Previous
Plus / Next
Hydro
Light / Colour therapy
Display
Radio / Bluetooth
Heater
Clean / Dry
Figure 8
-9-