Chapter 3 Demo Board Applications
RIGOL
User’s Guide for DS6000 Demo Board 3-1
Chapter 3
Demo Board Applications
In this chapter, the Demo board is used to demonstrate the functions of the oscilloscope and the
demonstration results of 25 kinds of signals are presented.
3.1 Common Signal Applications
3.1.1 Square Signal
1.
Signal Explanation
Signal Output Pin:
SQUARE
Square waveform with 1MHz frequency, 3.3Vpp amplitude and 50% duty cycle.
2.
Functions
Basic signal, edge trigger, duty cycle measurement
3.
Demonstration and Result
Connect the signal output pin SQUARE and GND to CH1 of the oscilloscope properly using the
probe;
Set the trigger type to “Edge”, the trigger mode to “Auto” and the vertical scale to “2 V”; adjust
the vertical position and trigger level to appropriate values to make the oscilloscope trigger
stably; enable “+Duty” and “Vpp” measurements and enable statistic function. The
demonstration result is as shown in the figure below.
Figure 3-1 Demonstration Result of Square Waveform
Duty Cycle Measurement
www.
GlobalTestSupply
.com
Find Quality Products Online at:
