Rigol DM3068, Руководство по обслуживанию

Страница: 16 / 70

RIGOL Chapter 1 Specifications
Service Guide for DM3068 1-2
Continuity Test
2000.0Ω 1mA 0.002 + 0.010 0.008 + 0.020 0.010 + 0.020 0.0010 + 0.0020
[1] Specifications are for 90-minute warm-up and 100NPLC integration time. For integration time <100NPLC, add the appropriate “RMS Noise Adder”
listed in the following table.
[2] 10% overrange on all ranges except DCV 1000V and DCI 10A range.
[3] Relative to calibration standards.
[4] For each additional volt over ± 500 V, add 0.03mV error.
[5] For continuous current > 7A DC or 7A AC RMS, 30 seconds ON and 30 seconds OFF.
[6] Specifications are for 4–wire resistance measurement or 2–wire resistance measurement using REL operation. Without REL operation, add 0.2 Ω
additional errors in 2-wire resistance measurement.
[7] Accuracy specifications for the voltage measured at the input terminal only. 1 mA test current is typical. Variation in the current source will create
some variation in the voltage drop across a diode junction.
Performance Versus Integration Time – 50Hz (60Hz) Power-line Frequency
Integration
Time
Number of
Power line
Cycles
(NPLC)
Resolution
[1]
(ppm Range)
NMRR
[2]
(dB)
Readings/s
[3]
RMS Noise Adder
[4]
(% of Range)
50Hz 60Hz DCV 20V
DCV 2V
200V
Resistance 2kΩ
20kΩ
DCV 1000V
DCI 2mA
200mA
DCV 200mV
Resistance 200Ω
DCI 10A
0.006 2.7 0 10000 10000 0.0006 0.0007 0.0015 0.0040
0.02 1.6 0 2500 3000 0.0004 0.0004 0.0008 0.0025
0.06 1 0 833 1000 0.0003 0.0003 0.0006 0.0025
0.2 0.5 0 250 300 0.0001 0.0002 0.0003 0.0015
1 0.22 60 50 60 0 0.0001 0.0002 0.0004
2 0.17 60 25 30 0 0 0.0001 0.0003
10 0.08 60 5 6 0 0 0 0.0002
100 0.035 60 0.5 0.6 0 0 0 0
[1] Typical value. Resolution is defined as the typical 20V range RMS noise (using auto zero “Once”).
[2] Normal mode rejection ratio for power-line frequency ±0.1%. For power-line frequency ±1%, subtract 20dB. For ±3%, subtract 30dB.
[3] Maximum rate for DCV, DCI, 2-wire resistance and 4-wire resistance functions.