Riftek IDK Series, Руководство пользователя

Страница: 8 / 15

Wheel diameter measuring gauge, IDK
IDK [Revision 2.2] 4th September 2017
8
- the separation point is indicated at the top side of the screen in the reverse indica-
tion regime.
10.2. Image brightness set-up
To change the display brightness it is necessary to:

turn the power on (press Red button).;

press Blue button and keep it pressed for more than three seconds;

display will show “
Up
”;

press Blue
button again than “
brt X
” message appears on the display;

choose the necessary brightness value by Green button pressings;

to save the changed parameters press Red button
the display shows “
SAUE
”
message, press the Green button to confirm saving and Red to cancel saving
of the changed parameters;
At brightness choosing one should take into account that increased brightness
enhances power consumption and decreases the period till battery recharge moment.
10.3. Millimeters-Inches-Tapes display set-up
To change the mode it is necessary to:

turn the power on (press Red button).;

press Blue button and keep it pressed for more than three seconds;

display will show “
Up
”;

press Blue bu
tton again until the either “
SI
” or “
Inch
” message appears on the
display. “
SI
” – measuring results will be shown in mm, “
Inch
” – measuring re-
sults will be shown in inches
, “Tape”;

choose the necessary value by Green button pressings;

to save the changed parameters press Red
button the display shows “
SAUE
”
message, press the Green button to confirm saving and Red to cancel saving
of the changed parameters