Riftek IDK Series, Руководство пользователя

Страница: 6 / 15

Wheel diameter measuring gauge, IDK
IDK [Revision 2.2] 4th September 2017
6
9.2. Single measurement
To perform measurement, it is necessary to:

turn the power on (press Red button).
The display shows “
- - - - -
”;

place the gauge onto the wheel;

make sure the ball supports are tight against the roll surface and side sup-
ports are adjacent to the edge of the wheel;

press Green button.

in a 1 second the display will show the value of the wheel diameter.
For viewing the result of measurement with indication discreteness of 0.01mm (it
is accessible only in a mode of direct indication) it is necessary to press Blue button,
thus displayed result will be shifted to the left on one digit. Next pressing Blue button will
lead to return of indication to a starting position:
9.3. Measurement with averaging
The program of the wheel diameter calculation contains an averaging algorithm
that allows eliminating the surface defects influence on the diameter measuring result.
All the results of metering, performed after the
Red button pressing, are averaged. The
measurement is meant to be Green button pressing.
To carry out measurements it is necessary to

turn the power on (press Red
button). The display shows “
- - - - -
”;

place the gauge onto the wheel

make sure the ball supports are tight against the roll surface and side sup-
ports are adjacent to the edge of the wheel;

press Green button;

display shows the value of pressing counter
“
n x
”, where
x
– quantity of av-
eraged values;

in a 1 second display shows an average value over the set of metering (over
the quantity of Green button pressings)

move the gauge to a new position and repeat the measuring.
(The total quantity of measurements averaged in this way can run up to 9999.)