Riello RX 500 S/PV, Регулируемая работа

Страница: 20 / 60

20138630
18 GB
Technical description of the burner
Key Fig. 9:
Tab. H
Times
Tab. I
AL Alarm device
AUX Auxiliary output
Dbr Lead connection
Reset button (info button)
EK2 Remote reset button
FSV Flame signal amplifier
ION Ionisation probe
K... Relay contact
LED Warning light with 3 colours
LP Air pressure switch
LR Load controller
LR-OPEN Load controller OPEN
LR-CLOSE
Load controller CLOSED
M Fan motor
NT Power supply unit
P LT Pressure switch valve test
Pmax Max. pressure switch
Pmin Min. pressure switch
POC Closure test
PV Pilot valve
QRA... UV flame detector
R Control thermostat or pressure switch
SA Actuator
SA-KL Low flame actuator
SA-NL High flame actuator
SA-R Feedback actuator
SA-Z Actuator CLOSED
SA-ZL Ignition load actuator
SL Safety loop
STB Safety limit thermostat
SV Safety valve
V1 Fuel valve
V2 Fuel valve
V2a Fuel valve
W Limit pressure switch or thermostat
Z Ignition transformer
µC µC controller
Input/output 1 signal (ON)
Input/output 2 signal (ON)
Input 1 permitted signal (ON) or 0 (OFF)
/reset
(EK1)
TSA Safety time
tw Standby time
t1 Pre-purging time
t3 Spark pre-ignition time
t3n Post-ignition time (P257 +0.3 seconds)
t4
(depending on
the application) Interval: end of safety time - fuel valve 1 ON
Interval: end of safety time - fuel valve 2 ON
Interval: end of safety time - load controller
reset
t5 Interval: Pilot valve OFF - load controller
reset
t8 Post-purging time
t9
(depending on
the application) Interval: Fuel valve 1 ON - pilot valve OFF
Interval: Fuel valve 2 ON - pilot valve OFF
t10 Time specified for air pressure switch status
message (timeout)
t11 Actuator opening time (timeout)
t12 Actuator closing time (timeout)
t22 2nd safety time
td1 Air pressure test
td2 Gas pressure test
td3 Gas valve filling test
td4 Gas valve bleed test