Riello 3768000, Инструкции по установке, использованию и обслуживанию

Страница: 8 / 36

2902768
5 GB

The intake-tube / burner system must not allow a loss of over 2 m
3
/h at 0.5 mbar:
for instance, the above requirements will be met if you use flues for pressure exhaust of flue gases (the
condensation kind).
 Make sure the air intake tube’s inlet is positioned so that it is not likely to be obstructed by foreign matter
and, where necessary, use suitable screens.
 The temperature of the incoming air must not exceed 60 °C ;

The inside diameter of the hose must be at least 80 mm.

The intake tube can be up to 6 metres in length.
Warning : length is reduced if there are bends in the intake section.
For instance, using a tube with a smooth inside surface, you must allow for the following losses:
- for each 45° bend, tube length is reduced by 0.5 m;
- for each 90° bend, tube length is reduced by 0.8 m.
BURNER INSTALLATION MUST COMPLY WITH ONE OF THE INSTALLATIONS ILLUSTRATED IN THE
FIGURES BELOW.

Under no circumstances should the air’s entry in the hose intake area be obstructed.

The hose must not be blocked in any way or feature a shutting device (valves, membranes etc.).
3.3 GAS SUPPLY LINE
ATTENTION
S7851
S7853
S7876
1 2 3 4 5 6 M1 7 8 9 10 11 12 M2 13 M3 14
D4208