Riello 20171510, Инструкции по установке, использованию и обслуживанию

Страница: 31 / 60

29 20171652 GB
E-display control
6.1 User interface UI300
Display
The display guides the user through different menus with
pictograms and it shows:
–
menu structure
– operating statuses
– parameters
– error messages
Back key
Cursor keys
Enter key
6.2 Menu features
The menu is divided into five paths:
INFO
MANUAL MODE
SETTINGS
DATA PROCESSING (access level 1 required)
6 E-display control
Go back to the previous window
S9620
Fig. 34
Cursor keys are used to navigate inside the
menu. Right arrow and left arrow keys are
used to progressively move to the selected
line. At the end of the selected line, the cursor
goes to the lower line, if any.
In case of menus with several lines, it is
possible to move to upper or lower lines by
pressing the keys. As regards the screens
with parameters, it is possible to move from
one field to the other.
With the Enter key it is possible to recall the menu in the
boot screen. Therefore, it will be possible to open a
selected sub-menu from a menu window. Using the
Enter key in a parameter window, it is possible to
transfer set values.
If the ENTER key lights up in red, it is possible to reset
faults on BT330.
If the Enter key is steady red, a fault is displayed and an
automatic restart is performed.
INFO
MANUAL MODE
SETTINGS
DATA PROCESSING
By following the INFO path, it is possible to obtain
information concerning:
–
burner
– faults
– software version
– display of checksums
– serial number
– position of actuators (current position of valves for
each duct)
– digital inputs/outputs
MANUAL MODE should be used to:
–
manually enable and disable the burner
– set the internal load
By following the SETTINGS path it is possible to set the
following items or obtain information about them:
–
password
– burner settings (display and settings)
– settings of the actuators (display)
– adjustment of air/fuel
– delete a curve
– display settings
Use DATA PROCESSING to:
–
make data backup from BT330 to user interface
– restore data from User Interface to BT330