Riele Photometer 5010 V5+, Руководство по обслуживанию

Страница: 18 / 95

3.3 SERVICE TOOLS
S19 Automatic Results
This operation works only with standard cuvette
adapter!
The function invokes by [START] a test based on the
calculation procedure 1
↔
C/F (OM chapter 5.4.1).
For each setting parameter a leading identification
number is shown. If the identification number is
selected on the keyboard, the corresponding setting
parameter becomes configurable.
After setting parameters like wavelength, factor, delay
time, unit, … the procedure is started by [OK].
By setting delay time the intervals between the
measurements can be defined.
The procedure is working in an open loop and
produces results as long as the [EXIT] is pushed.
By [ZERO] an automatic zero adjustment can be done.
To a key actuation the system reacts possibly only after
three seconds.
A U T O M A T I C R E S U L T S
E X I T S T A R T
M E T H O D N O . 1 C / F
1 - W A V E L E N G T H 3 4 0 n m
2 - F A C T O R 1 . 0 0 0 E X I T
3 - T E M P E R A T U R E 3 7 C
4 - D E L A Y 0 s
5 - U N I T O K
6 -
7 -
8 -
1 2 3 4 5 6 7 8 P 1 / 3
D E L A Y 5 C / F
4 2
E X I T M O D E W A S H Z E R O R E S U L T
1.234
S20 BCC of Method/Curve
To check the correct storing of a user-defined method
or curve, the special test byte BCC concerning the data
in the memory is used. With this service program the
BCC of a method can be determined.
With [M] the BCC of a method can be tested.
With [C] the BCC of a curve can be tested.
B C C O F M E T H O D / C U R V E
E X I T M C
RIELE BERLIN Photometer 5010 V5+ 3.3.13 11.03.2009