12
1. Locate blowing port of your vac.
2. Insert the locking end of the hose
assembly into the blowing port of the
vac. The hose should snap into place.
To remove the hose from the vac,
press the release button in the hose
assembly and pull the hose out of the
vac inlet.
Pull Up to Unlock
Wheel Locks
Blowing Port
4. Dump the drum contents into the
proper waste disposal container.
5. Replace the drum by reinserting into
the cavity and push until it snaps into
place.
Moving the Wet/Dry Vac
To maneuver the vac, the metal handle in
the rear of the unit should be positioned
in the upright position for ease of
movement. Be sure to unlock the back
wheels by pulling up on the wheel locks
before moving the vac.
Blowing Feature
Your vac features a blowing port. It can
blow sawdust and other debris. Follow
the steps below to use your vac as a
blower.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage wear ear protectors
when using the vac/blower for
extended hours or when using in a
noisy area.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
!
!
!
Locking End
Hose
Assembly
Operation (continued)
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn vac on and you are ready to use
your vac as a blower.
SP6659-3 WD7000 ES.qxd 3/26/08 9:44 AM Page 12
