Vac Inlet
Port
Hose
Locking
Tab
(I)
5
INTRODUCTION
UNPACKING
Remove contents of carton. Check each item against
the Carton Contents List.
Contact 1-800-4-RIDGID (1-800-474-3443) from the
US and Canada, 01-800-701-9811 from Mexico or
[email protected] if any parts are damaged or
missing.
CARTON CONTENTS LIST (Fig. 1)
Key Description Qty
A* Powerhead Assembly .................................................. 1
B* Dust Drum Assembly .................................................. 1
C* Qwik Lock™ Filter ........................................................ 1
D* Rear Wheel ................................................................... 2
E* Caster ............................................................................ 2
F Utility Nozzle ................................................................. 1
G Extension Wand ........................................................... 3
H Car Nozzle ..................................................................... 1
I Tug-A-Long Positive Locking Hose with Dual-Flex ... 1
J Owner’s Manual ........................................................... 1
* These parts come preassembled.
C*
D*
H
I
E*
B*
A*
G
J
F
ASSEMBLY
WET/DRY VAC ASSEMBLY (Fig. 2)
1.
To Attach the Powerhead Assembly to Dust Drum:
Place Powerhead Assembly (A) on top of Dust
Drum (B) with the Power Switch aligned with the
Vac Inlet Port. Be sure Powerhead Assembly is fully
seated on the Dust Drum.
2. Press in on the Two Latches, located on either side
of the Dust Drum (B) until they snap into place,
securing the Powerhead Assembly to the Dust
Drum.
3.
To Remove the Powerhead Assembly: Pull out on
the Two Latches and lift Powerhead Assembly from
the Dust Drum. Do not force the Latches to rotate
more than slightly outside Drum flange.
Pull Out
And
Lift Up
(A)
(B)
Drum
Latch (2)
ATTACHING AND REMOVING VACUUM HOSE
(Fig. 3)
1.
To Insert Hose: Locate the larger end of the
Tug-A-Long Positive Locking Hose with Dual-Flex
(I). Push the Tug-A-Long Positive Locking Hose
with Dual-Flex into the Vac Inlet Port. Engage the
Hose Locking Tab onto the lip of the Vac Inlet
Port. The Tug-A-Long Positive Locking Hose with
Dual-Flex should snap into place.
2.
To Remove Hose: Press the Hose Locking Tab
and pull the Hose end straight out of the Vac Inlet
Port.
Fig. 3
Fig. 2
Fig. 1
