RIDGID SP-330, Руководство оператора

Страница: 6 / 32

SP-330, SP-330D, SP-500, SSP-1000 Submersible Sump Pumps
Ridge Tool Company
4
Specifi cations
Motor:
Type . . . . . . . . . . . . . . . . . . . 1/3 HP & 1/2 HP
Shaded Pole
1HP Split Phase
Rating . . . . . . . . . . . . . . . . . . 120V, Single Phase
1/3 HP, 9.5 Amps
1/2 HP, 10 Amps
1HP, 9.8 Amps
Pump
1/3 HP . . . . . . . . . . . . . . . . . 3100 GPH @ 0 Ft.
1/2 HP . . . . . . . . . . . . . . . . . 4400 GPH @ 0 Ft.
1HP . . . . . . . . . . . . . . . . . . . 5400 GPH @ 0 Ft.
Liquid temperature range . . . 40F to 120F
Model Cut-in Cut-out
SP-330 & SP-500 9 inches 4 inches
SP-330D 10-13 inches 4-7 inches
SP-1000 7 inches 3 inches
Performance Curve
Performance Chart
Discharge Head 0' 5' 10' 15'
SP-330 Gallons/Hour 3100 3000 2700 1680
SP-330D Gallons/Hour 3100 3000 2700 1680
SP-500 Gallons/Hour 4400 4100 3200 2000
SSP-1000 Gallons/Hour 5400 4860 4200 3360
Pump Installation
• Pump should only be used to pump
clear water. Do not use to pump
fluids such as gasoline, fuel oil,
or kerosene. Do not use in a flam-
mable or explosive atmosphere. Improper use
could result in personal injury and/or death.
To prevent property damage,
serious injury, or death, proper installation of
the pump is required. The following procedures
should be followed:
• Pump must be plugged into an outlet receptacle
that includes a Ground Fault Circuit Interrupter
(GFCI) (Figure 1).
• Always disconnect the power source before
attempting to install, service, relocate, or main-
tain the pump. Never handle a pump or pump
motor with wet hands or when standing on wet
or damp surface or in water.
Installation
1. Construct a sump pit from concrete, steel, or
plastic that is at least 24" deep and at least 11"
in diameter (Figure 2). If the sump already exists,
make sure it is the proper size.
Figure 2 – Submersible Pump Installation
2. Make sure the electrical outlet is grounded and
is rated for 115 volts and at least 15 amps. The
outlet must be protected by a Ground Fault Circuit
Interrupter (GFCI).
Use of a grounded receptacle that
is protected by a GFCI reduces risk of a fatal electrical
shock.
3. Inspect the power cord and plug for damage. If the
plug is missing the grounding prong or the cord is
damaged, do not install the pump until the cord
has been replaced.
1000 2000 3000 4000 5000 6000
25
20
15
10
5
Gallons Per Hour
Discharge (Feet)
0
SP-300
SP-300D
SP-500
SSP-1000