English – 15
nano
TM
Service and Repair
WARNING
Improper service or repair can make the nanoReel
unsafe to operate.
Service and repair of the SeeSnake nanoReel must be
performed at a RIDGID Independent Authorized Service
Center.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
Disposal
Parts of the nanoReel contain valuable materials that
can be recycled. Companies that specialize in recycling
may be found locally. Dispose of the components in
compliance with all applicable regulations. Contact your
local waste management authority for more information.
For EC Countries:
Do not dispose of
electrical equipment with household waste!
According to the European Guideline
2002/96/EC for Waste Electrical and
Electronic Equipment and its implementation
into national legislation, electrical equipment
that is no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Table 3
Troubleshooting
Problem
Probable Fault Location
Solution
Camera image not seen
No power to SeeSnake CCU or
micro
CA-300
camera monitor connector
Check power cord is correctly plugged in
Check the switch on monitor/display unit
Connections faulty
Check alignment and pins of connection to the
nanoReel system unit from CCU or display unit.
Check orientation, seating, and pin condition in
the SeeSnake connection.
Monitor set to wrong source
Set video source as described in display unit
operator’s manual.
Batteries low
Recharge or replace batteries.
“SOS” code blinking on LCD*
No video signal
Check source setting of monitor and
re seat cable connection.
*
The light on the LCD will only blink the “SOS” code on some SeeSnake CCUs.
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30
