8 - English
SeekTech
®
ST-33Q
4� Inspect any other equipment being used per its
instructions to make sure it is in good, usable
condition�
5� If any problems are found, do not use the equipment
until the problems are corrected�
Work Area and Equipment Set Up
WARNING
Set up the ST‑33Q and work area in accordance with these
procedures to reduce the risk of injury from electrical
shock, fire, and other causes and to prevent damage to
the ST‑33Q.
1� Check work area for the following:
•
Adequate lighting�
•
Flammable liquids, vapors, or dust that may ignite� If
present, do not work in area until sources have been
identified and corrected� The ST‑33Q is not explosion
proof� Electrical connections can cause sparks�
•
Clear, level, stable dry place for operator� Do not use
the machine while standing in water�
•
Clear path to electrical outlet that does not contain any
potential sources of damage for the power cord when
using external power�
2� Inspect the line to have a signal applied to it� The
line must be metal to allow the ST‑33Q to locate
it� If using the transmitter on insulated conductors,
ground the target conductor at each end to ensure
that the signal will be strong enough to locate� The
ST‑33Q is not designed to provide high voltage
insulation or protection� Do not use where a danger
of high voltage contact is present�
3� Determine the presence of chemicals� If chemicals
are present, it is important to understand the
specific safety measures required to work around
the chemicals� Contact the chemical manufacturer
for required information�
4� Determine the correct equipment for the application�
The ST‑33Q is made to locate conductors
underground� Inspection and locating equipment
for other applications can be found in the Ridge
Tool Catalog or online at www�RIDGID�com or www�
RIDGID�eu�
5� Make sure all equipment has been properly
inspected�
6� Evaluate the work area and determine if any
barriers are needed to keep bystanders away�
Bystanders can distract the operator during use� If
working near traffic, erect cones or other barriers
to alert drivers�
NOTICE
Do not place two ST‑33Qs in inductive Mode
with the power ON within 10 ft [3 m] of each other. The
inductive output of each ST‑33Q can reinforce the load of
another ST‑33Q and can possibly damage one or both of
the units.
Kick Stand Positioning
The kick stand on the back of the ST‑33Q allows the unit
to be positioned on its back which allows easy viewing
of the screen and access to the controls� Positioning
the ST‑33Q on the kick stand also helps place the unit
in a convenient position for locating when using Direct
Connect Mode�
ST‑33Q Magnetic Clips
The ST‑33Q contains advanced connection clips that
can be attached mechanically or magnetically� The front
end of the clip includes a scraper tip
(See Item 1, Figure
6)
which can be used to remove rust or paint� Before
connecting the ST‑33Q leads to a flat, metal surface
such as a steel junction box or fire hydrant, use the tip
of the clip to scrape off rust and place the teeth of the
clip (
See Item 2, Figure 6)
in contact with the metal� The
teeth and the finger‑guard
(See Item 3, Figure 6)
will
support the clip and the magnet
(See Item 4, Figure 6)
will hold the clip to the metal�
NOTE
The magnetic clips provided with the ST‑33Q
contain strong magnets. Do not place the clips near data
storage devices, credit cards, ATM cards, or other
magnetically encoded data.
3
4
1
2
Figure 6 – ST‑33Q Magnetic Clip