20 - English
SeekTech
®
ST-33Q
Table 6
Troubleshooting
Problem
Solution
ST‑33Q will not turn ON
Check orientation of batteries
Check that batteries are charged
Check that the battery contacts are clean and unbent
Receiver will not pick up the line
transmitter’s signal
Check that the circuit is complete
Check that the transmitter is in the correct mode� See the descriptions for
Direct Connect Mode, Inductive Mode, and Inductive Clamp Mode�
Check that the receiver and the ST‑33Q are set to the same frequency (for
example, some receivers will use 93,622�9 Hz or 93,696 Hz instead of 93
kHz)� Create custom frequencies to exactly match the receiver�
Ensure the proper functions are activated on the receiver�
Press up the Up Arrow Key to increase the power output
Ensure adequate grounding and improve if possible
LCD screen completely dark or light
when the ST‑33Q is ON
Power the ST‑33Q OFF and ON
Check and adjust LCD brightness from the Tools Menu
If exposed to excessive heat or sunlight, allow the ST‑33Q to cool
ST‑33Q appears stuck in one mode
and will not reset
Remove and replace or recharge batteries�
Apply external power source