RIDGID SeekTech ST-33Q, Руководство оператора, Страница: 13 / 22

English - 13
SeekTech
®
ST-33Q
Figure 15 – Inductive Clamp Connected to a Cable
5� Press the Power Key to turn ON the ST‑33Q
and select a frequency for locating� Check the
circuit and adjust the current� The ST‑33Q will
automatically set the frequency to 33 kHz the
first time Inductive Clamp Mode is used� After the
first use, the ST‑33Q will automatically use the
frequency last used in Inductive Clamp Mode� The
ST‑33Q will also default to 50 percent power level
to conserve battery power while in Inductive Clamp
Mode�
6� After completing the location, press the Power Key
to turn OFF the ST‑33Q before disconnecting
the inductive clamp�
Inductive Mode
WARNING
Disconnect the lead clips from any external conductors
before switching the ST‑33Q to Inductive Mode. If the
lead clips are connected to an external conductor and
the ST‑33Q is switched to Inductive Mode, a warning will
appear and an operator override will be required.
When using Inductive Mode, only 8 kHz and 33 kHz
frequencies will be available for use on the ST‑33Q�
To use the ST‑33Q in Inductive Mode, perform the
following:
1� Place the ST‑33Q so the orientation mark located
on top of the ST‑33Q aligns with the target conductor
( See Item 1, Figure 16) �
1
Figure 16 – Orientation Marks Aligning with the
Target Conductor
2� Place the ST‑33Q over the line to be traced ( See
Figure 17) �
Figure 17 – Inductive Mode Alignment
3� Press the Power Key to turn ON the ST‑33Q�
Press the Inductive Mode Key to toggle the
ST‑33Q between Direct Connect Mode and
Inductive Mode�
Figure 18 – Inductive Mode Screen
Do not use clips and leads in Inductive Mode� The
ST‑33Q will automatically set the frequency to 33 kHz
the first time Inductive Mode is used� After the first use,
the ST‑33Q will automatically use the frequency last
used in Inductive Mode�