RE 60 Electrical Tool
27
For EC Countries: Do not dispose of elec-
trical equipment with household waste!
According to the European Guideline 2002/ -
96/ EC for Waste Electrical and Electronic
Equipment and its implementation into nation-
al legislation, electrical equipment that is no
longer usable must be collected separately and disposed
of in an environmentally correct manner.
SYMPTOM
Tool will not turn ON
when ON/OFF button is
pressed.
Tool will not run when
trigger is depressed.
Green light flashes.
Tool turns OFF either
when trigger is
depressed or in the
middle of a cycle. Red
LED glows.
Yellow LED blinks repeat-
edly as long as tool is
turned ON and tool func-
tions properly.
Yellow LED glows con-
tinuously and tool will
not begin press cycle
when trigger switch is
depressed.
Yellow LED glows when
tool is turned ON.
The connections
produced are not
complete.
Troubleshooting
Battery is completely discharged or battery has
failed.
Battery not properly inserted into handle of tool.
Battery charge is too low.
Tool or battery is too cold or too hot.
Scheduled maintenance/recalibration is required
after 30,000 cycles.
Scheduled maintenance/recalibration is mandato-
ry after 32,000 cycles. Tool is “locked” and will not
function until serviced..
Tool malfunction detected.
Used wrong interchangeable head/insert for the
cable size or material.
The tool was not square to the connector.
Tool is in need of repair.
Insert fully charged battery/recharge battery.
Check to assure battery is fully inserted.
Insert fully charged battery/recharge battery.
Bring tool and battery to correct operating range
between 23 °F (-5 °C) and 122 °F (50 °C) by allow-
ing the tool to sit in a conditioned room
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Service
center.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorizedl Service
center.
Remove and reinsert fully charged battery. Be sure
to repress fitting. If LED continues to glow,Contact
RIDGID Technical Service Department at (800)
519-3456 for nearest Authorized Service center.
Install the correct interchangeable head/insert .
Redo the joint. Make sure that the tool is square
to the connector.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Service
center.
POSSIBLE REASONS
SOLUTION
RE 60 Electrical Tool
SYMPTOM
POSSIBLE REASONS
SOLUTION
28
RE 60 Diagnostic Codes
n
o
c
I
Description
Status
LED
Green
Glows
Tool is ON.
Blinks
Battery needs charging..
Red
Glows
Out of temperature range -10 °C to +50 °C.
Yellow
Blinks
Service indicator after 30,000 cycles. NOTE: Tool will lock after 32,000 cycles.
Glows
Machine is locked – Service after 32,000 cycles or after a tool malfunction.
Figure 7 – LED Diagnostic Codes
Oil leaks from tool.
Motor runs but tool will
not complete a cycle.
Dies stop during opera-
tion.
Troubleshooting
(Continued)
Seal or mechanical problems.
Oil level low.
Oil level low.
partment at
Contact RIDGID Technical Service De
(800) 519-3456 for nearest Authorized Service
center.
partment at
Contact RIDGID Technical Service De
(800) 519-3456 for nearest Authorized Service
center.
Contact RIDGID Technical Service De partment at
(800) 519-3456 for nearest Authorized Service
center.
