RIDGID R5013, Руководство оператора

Страница: 6 / 32

6 - English
FEATURES
PRODUCT SPECIFICATIONS
Input ........................................120 V, 60 Hz, AC only, 7.5 A
Switch .......................................................... Variable Speed
Hammer Speed ........................................... 0-51,000 BPM
No Load Speed .................................. 0-2,700 r/min. (RPM)
ASSEMBLY
UNPACKING
This product has been shipped completely assembled.

Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this
Assembly
section are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.

If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
INSTALLING THE AUXILIARY HANDLE
ASSEMBLY
See Figure 1, page 11.
An auxiliary handle is packed with the drill for ease of
operation and to help prevent loss of control. The handle
can be rotated 360°, and it can be mounted on either side
for right or left hand use.
To install the auxiliary handle assembly:

Loosen the handle assembly by turning the handle
counterclockwise.

Install the auxiliary handle assembly in the desired
operating position.

Securely tighten by turning the auxiliary handle clockwise.
Be sure the auxiliary handle is securely tightened against
the depth stop clamp. This secures the depth stop rod at
the desired depth of cut. It also secures the auxiliary handle.
NOTE: For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
auxiliary handle.