21 — English
ASSEMBLY
Wipe a drop of oil onto the washer where it contacts the
cutting wheel.
Place an outer washer onto the spindle. The double “D”
flats on the washer align with the flats on the spindle. Be
sure the hollow side of the washer is against the cutting
wheel.
Place wheel nut on spindle.
Depress the spindle lock button and rotate the cutting
wheel until the spindle locks.
Using the wheel wrench provided, tighten nut securely.
Release the spindle lock button.
Close and lock the wheel guard.
ALIGNING THE LASER GUIDE LINE
See Figure 25.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Draw a line on the tile. When the laser guide switch is turned
on it will generate a red line on the work surface. This line will
let you see your mark and the laser guide line at the same
time, and will assist you in lining up the mark for more ac-
curate cutting of the tile.
Align the laser line and the mark with the wheel in the
cutting position using the laser adjustment dials.
Make several practice cuts on different styles and thickness
of material. Repeat the steps as necessary.
To adjust the laser:
Plug in the saw and push the laser guide switch to show
the laser guide line.
Position the laser line near the left edge of your mark on
the work surface.
Turn the laser left/right adjustment dial move the laser
line either left or right.
To move the laser line more towards the front or back
of the workpiece, turn the laser front/back adjustment
dial.
When all adjustments are complete, secure adjustments
by turning the lock knob to the right.
•
To reduce the risk of injury, the user must read and understand operator’s manual.
•
Do not fill water bath above maximum water fill line.
•
Do not stack or store tiles on water trays.
•
Do not expose to rain or other damp locations.
•
Always inspect and replace damaged cutting wheels before operating the tool.
•
Never use wheels that have openings, grooves, or teeth on this tool.
•
Turn off tool, wait for the wheel to stop moving and disconnect the power
to the tool before servicing, when changing cutting wheels, or cleaning.
•
Never operate the tool without the wheel guard securely closed.
•
Do not remove the wheel guard.
•
Wear eye, hearing, and respiratory protection when operating the tool.
WARNING
DANGER
LASER RADIATION AVOID DIRECT EYE EXPOSURE
MAXIMUM OUTPUT: <5mW WAVELENGTH: 630-660nm
CLASS IIIa LASER PRODUCT
laser front/
BacK
adJustMent
dial
red
line
laser Guide
switch
laser left/
riGht
adJustMent
dial
laser
locK KnoB
Fig. 25
