17 — English
ASSEMBLY
Fig. 16
Miter
Guide
KnoB
locK
KnoB
Miter
Guide
slidinG
taBle
fence
INSTALLING THE MITER GUIDE
See Figure 16.
The miter guide can be used from both the left and right side
of the cutting wheel.
Place the slot on the underside of the miter guide on the
sliding table fence.
Lock the miter guide securely to the table by turning the
miter guide knob clockwise.
To adjust angles:
Loosen the lock knob.
Set to the desired angle by moving the guide left or
right.
Tighten the knob securely before turning on the saw.
INSTALLING NEVER DRY VALVE, WATER PUMP,
AND WATER TANK
See Figure 17.
Unscrew the connector from the never dry valve.
From inside the water tank, place the threaded end of the
never dry valve into the hole on the side of the tank.
Secure in place by retreading the connector to the
valve.
Connect a garden hose to the never dry valve or fill the
water tank two-thirds full by pouring water to the two-
thirds level of the tank.
Center the water tank on the lower brace of the leg stand
and push the tank firmly against the center brace until it
locks into place.
Push the clear tube of the T-connector assembly over the
garden hose attachment on the leg stand. Secure with a
hose clamp.
Push the short clear tube of the T-connector assembly
over the connector on the back of the diverter valve (as
shown in figure 11).
Attach the long clear tube (with the check valve) to the
submersible water pump and set the pump in the bottom
of the water tank. Secure tube with hose clamps.
Push back rubber boot on electrical cord and plug pump
into an outlet or extension cord. Pull boot over cord con-
nections to help keep water off the plug.
Fig. 17
connector
neVer drY
ValVe
water
tanK
water
PuMP
ruBBer
Boot
checK
ValVe
