12 — English
UNPACKING
See Figure 5.
This product requires assembly.
Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has influ-
enced the settings, refer to specific procedures explained
in this manual.
If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not oper-
ate this tool until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces-
sories not recommended for use with this tool. Any
such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in ac-
cidental starting and possible serious personal
injury.
ASSEMBLY
ATTACHING HANDLES TO THE READY RACK™
TILE CARRIER AND WATER TANK
See Figure 6.
The long handle should be attached to the Ready Rack™ Tile
Carrier while the shorter handle is used on the water tank.
On both sides of the Ready Rack™ tile carrier and the water
tank are slots to be used for handle installation.
Place the handle below the slot then pull up on the handle
until it slides into the slot.
Repeat with the water tank.
Fig. 6
lonG
handle
short
handle
water
tanK
slot
readY racK™
tile carrier