15 — English
ASSEMBLY
Fig. 10
INSTALLING WATER SUPPLY VALVE
See Figure 10.
Unscrew the connector from the water supply valve and
remove the mounting bracket.
Align holes in mounting bracket with holes on top of
upper tube and secure in place using screws and nuts.
Slide the threaded end of the valve into the mounting
bracket hole and secure using the connector.
INSTALLING CLEAR TUBES AND CLEANING
NOZZLE
See Figure 11.
NOTE: Hose clamps secure clear tubes to valves, connec-
tors, etc. To attach a hose clamp, squeeze the ends of the
clamp together then slide the clamp over one end of a short
clear tube. Once the tube has been attached to a valve, con-
nector, etc., squeeze the clamps ends together and slide the
clamp over the tube covering the connector.
Grasp the diverter valve firmly then push the end of the
short clear tube over the left connector. Secure with a
hose clamp.
Slip the tube onto the valve assembly in the saw arm by
pushing the tube over the connector. Secure with a hose
clamp. Attach the clear tube to leg stand using the tube
clips on top of the leg stand.
Holding the diverter valve, connect the long clear tube
(with the cleaning nozzle) to the right side of the diverter
valve by pushing the tube over the connector. Secure
with a hose clamp. Store the nozzle in the cleaning nozzle
storage.
Fig. 11
connector
clear
tuBe
diVertor
ValVe
ruBBer
Boot
clear tuBe
with cleaninG
noZZle
water
fill
line
inner leG
asseMBlY
water
suPPlY
ValVe
cleaninG
noZZle
storaGe
clear
tuBe
connector
water suPPlY
ValVe
screws
hose
claMP
nuts
