Ridetech airpod Series, Инструкция по установке и эксплуатации

Страница: 6 / 20

6
Mounting the RidePro Air Valves
• The valves, like the compressor, are sealed and can be mounted
in the same locations. Although if the vehicle will be exposed to
freezing temperatures it is a good idea to mount them in the engine
bay if possible to reduce the possibility of freezing.
• They can be mounted in any position.
• Attach the ground strap to a good, clean ground (preferably the
frame).
• The exhaust port will be left open.
• The valve is held closed with the pressure in the tank. If tank
pressure drops below air spring pressure they will equalize,
Routing the Airline and Fittings
• Make all airline cuts with a razor or tubing cutter (part # - cut1000).
It must be clean and straight or it will not seal.
ttings are DOT approved push-to-connect style. They are very simple to use and are reusable.
tting back
tting and pull the airline out.
• ttings.
tting or damaging the air spring.
• All of our airlines are DOT approved so they are very strong. But keep them away from any sharp
edges. Also when passing through a hole in the frame use a grommet.
ers and exhaust manifolds.
• Use zip ties or other fasteners to secure the airline.
Mounting the Air Pressure Sensors
• These sensors are voltage based and do not need to be grounded.
Ensure a
good ground
is used
use thread
sealant to
avoid leaks
Component Installation Instructions
& &
LevelPRO Part #: ARC4000L ARC4100L ARC4700L ARC4800L
RidePRO e2 Part #: ARC4000e2 ARC4100e2 ARC4700e2 ARC4800e2
Use Tubing Cutter
(part # CUT1000)
for straight ends.
•
!