Ricoh TCRU/ORU, Руководство по устранению неисправностей

Страница: 136 / 184

Coated paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0617:
[Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
• In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set
0615: [Output Trail Edge Press Setting] to [On].
• In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set
0616: [Output Fan Setting] to [On].
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0304: [Correct Output Paper Curl] to " Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if
the present value is "Small".
<If the decurler unit is not used>
Load the sheets the other way up.
Coated paper is being used.
In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0617:
[Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
• In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set
0615: [Output Trail Edge Press Setting] to [On].
• In the [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set
0616: [Output Fan Setting] to [On].
Trailing Edge of Stapled Sheets Close to the Paper Exit
Cause:
The trailing edge of the sheets may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
This may occur if:
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
9. Post-Processing Option Troubleshooting
134