T
echnical
B
ulletin
PAGE: 1/2
Model:
General (GW Models)
Date:
20-Dec-01
No.:
RGene010
Subject:
Series Print Mode
Prepared by:
K. Misugi
From:
Technical Services Dept., GTS Division
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
In response to complaints from customers that the intervals between jobs are too long
when sent in series, a new service switch has been added to improve performance.
New service switch:
Controller SP mode bit switch 2, bit 1
Series print mode On/Off
0:
Off (default setting)
1:
On
This switch has been added to the following GW models:
K-P1 (Kir-P1), J-P1, A-P3 (Adonis-P3), and R-C2 (Russian-C2).
Enter the printer controller service mode, access the bit switch settings display, then
change bit 1 of bit switch 2 to “1.”
Important:
Do not change any other settings. (The default setting is “0.”)
Descriptions:
Series print mode Off (default):
The machine starts to feed paper for the next job after the last sheet of the previous job
has fed out from the machine.
Series print mode On:
The machine starts to feed paper for the next job before the last sheet of the previous job
is fed out.
00000000
Bit 7
Bit 0
Change this bit to 1
