Ricoh NIB 450-E, Руководство пользователя

Страница: 49 / 120

Chapter 7 - 3
where subnets are used. See 7.6 Running Telnet, for instructions on how to enter
the other IP parameters.
7.1.1.5 Assigning IP Address with BOOTP Lite
This program uses the BOOTP protocol. The Network Interface Board must be on the
same network segment as the workstation that you are using to configure it. The TCP/IP
stack must be installed and operating. The BOOTP Lite program will not work in a
Windows PC Operating as a DHCP Server.
The BOOTPL16.exe program will work with a 16 Bit TCP/IP stack.
1. Copy the BOOTPL16.exe file to the Windows directory of your workstation.
2. Reset the printer.
Note: The Network Interface Board issues the BOOTP request for a finite period
of time. The print server must be freshly reset for this program to work.
3. From Program Manager under File, select Run \windows\ BOOTPL16.exe.
4. Pull down the Admin menu to Configure option.
5. Enter the IP address that you want to assign to the Network Interface Board, its
Subnet Mask (make sure it matches what you are using on your subnet), the Default
Gateway (your router's IP address), and the MAC address of the Network Interface
Board (Hardware Address, listed on the Status sheet as Ethernet Address). Use
colons as delimiters as shown on the status sheet rather than the dashes that
Windows uses.
6. Click on Go. You will get a message that the program is Verifying, and then it will tell
you whether the unit is active or not.
7. Wait for about five minutes for the Network Interface Board to reset. The Status sheet
should report the newly entered IP information.
8. Enter the MS/DOS box. At the command prompt enter:
ping [IP address of Network Interface Board] (continue until
you get a reply)
If it does not respond, verify that TCP/IP is enabled on the status sheet. If the status
sheet does not show the IP information, then repeat the above procedures.
7.1.1.6 Setting up IP and lpr Parameters
The Network Interface Board provides for a setup connection via the standard Telnet
port. To be able to make changes to a unit with factory default settings, you must logon
as "sysadm".
The default password is also "sysadm" (This password can be changed from the Telnet
utility). Section 7.6 Running Telnet, describes the use of the Telnet utility.
1. Telnet to the Network Interface Board (the login and password are both "sysadm").
2. Turn off the protocols that you are not utilizing (option 3).