Ricoh M116, Руководство по обслуживанию

Страница: 92 / 165

Firmware Updating
M116/M117 5-14 SM
5.3 FIRMWARE UPDATING

Never turn the machine's main power off while the firmware is being updated, as this
could damage the ECB or controller board.
5.3.1 CHECKING THE MACHINE FIRMWARE VERSION
To update the firmware for this machine, you need the most recent version of the firmware
(firmware file downloadable from the Internet).
1. Turn on the machine.
2. Press the "Menu" key.
3. Press the "Up" or "Down" key to select "List/Test Print", and then press the "OK" key.
4. Press the "Up" or "Down" key to select "Config. Page" or "Maintenance Pg.", and then press
the "OK" key.
5. Check the "Firmware Version” (Controller) and "Engine FW version" on the list of the pages.
5.3.2 UPDATING THE CONTROLLER FIRMWARE
Using the following procedure to update the controller firmware, be sure to print the configuration
page both before and after the update. Comparing pre- and post-update configuration pages
allows you to check whether or not the update was successful.
Follow the procedure carefully, and note that it will vary in parts depending on which version of the
firmware is currently installed.
Procedure
When updating firmware, always disconnect any other cable(s) than the one being used for the
update operation.
(When updating firmware via USB cable, first disconnect any network and phone line cables, and
when updating firmware via LAN cable, first disconnect any USB and phone line cables.)
1. Prepare:

Computer: Windows XP/Vista/7, Windows Server 2003/2003 R2, 2008/2008 R2

USB cable or LAN (Local Area Network) cable
2. Download the firmware files to your computer.

FwUpdateToolSP.exe (Service Mode execute file)

Setting.ini (Parameter setting)

xxx.brn (Controller Firmware)
3. Make a folder on a local drive of your computer and save the files there.
4. Connect a computer and the machine through a network or directly by USB.