Ricoh Laser AP1600, Руководство по установке

Страница: 30 / 68

Installing Options
18
2
Type 1 Printer: Installing
Envelope Feeder Type 2000
Note
❒
See the inside front cover of this
manual to confirm which printer
(Type 1 Printer or Type 2 Printer)
you have.
Important
❒
This unit is a tray that slides into the
optional paper feed unit. Without
the optional paper feed unit, this
envelope feeder cannot be used.
❒
The Type 1 Printer can have two
optional paper feed units installed
at a time. However, the envelope
feeder should be used in the top-
most optional paper feed unit (tray
2). It can not be used in the bottom-
most paper feed unit (tray 3).
❒
Do not slide more than one paper
tray out at a time. Having more than
one paper tray filled with paper in a
fully extended position could cause
the printer to tilt forward.
A
Confirm that the box contains the
following items.
• Envelope feeder
• Installation Guide
B
Pull out the second paper tray
(tray 2) of the optional paper feed
unit until it stops. After that, lift it
slightly, then pull it out.
Important
❒
The envelope feeder should be
used in the top-most optional
paper feed unit (tray 2).
Note
❒
Keep the paper tray with paper
in a cool and dry place.
C
While lifting the front of the en-
velope feeder, place the feeder
into the printer. Then slide it into
the printer until it stops.
Note
❒
When loading envelopes, see “
Type 1: Loading envelopes” in
the “Printer Reference”.
Type 1 Printer: Installing
Network Interface Board Type
2000
Note
❒
See the inside front cover of this
manual to confirm which printer
(Type 1 Printer or Type 2 Printer)
you have.
❒
Use the shielded twisted-pair
(STP) network interface cable.
❒
Network Interface Board can be at-
tached to either the left or right
side of the back of the printer. This
procedure is for attaching to the
left side.
❒
You cannot install two Network
Interface Boards at a time.