Ricoh D0C8, Руководство по обслуживанию

Страница: 450 / 1647

Electrical Components
D0CA/D0C9/D0C8/D0CB 4-216 SM
23.
Execute SP5-755-002 (Hide Administrator Password Change Scrn).
After you execute this SP and exit SP mode, the Home screen is displayed and user
functions can be used.
24.
Make sure that icons for scanner and fax are displayed and enter the values that you note
in Step 5.
•
SP5-193-001 (External Controller Info. Setting)
•
SP5-895-001 (Application invalidation / Printer)
•
SP5-895-002 (Application invalidation / Scanner)
•
SP5-985-001 (Device Setting / On Board NIC)
•
SP5-985-002 (Device Setting / On Board USB)
25.
If the security functions (HDD Encryption and HDD Data Overwrite Security) were applied,
set the functions again.
26.
Restore the original settings of the following SPs, referring to the SMC data obtained in
step 2.
SP5-825-001 does not download the following SP data to the new NVRAM. So you must
set them manually.
a. SP5-985-001(Device Setting: On Board NIC)
b. SP5-985-002(Device Setting: On Board USB)
27.
Ask the customer to restore their address book. Or restore the address book data using
SP5-846-052 (UCS Setting: Restore All Addr Book), and ask the customer to ensure the
address book data has been restored properly.
•
If you have obtained the backup of the customer’s address book data, delete the
backup immediately after the NVRAM replacement to avoid accidentally taking
out the customer’s data.
28.
Output all the SMC data with SP5-990-001 and make sure all the SP/UP settings except for
counter information are properly restored, by checking the SMC data obtained in step 2.
•
Check that the counters are reset.
29.
Make sure that the list output in step 7-1 through step 7-3 matches the destination
information in step 7-4. If not, set it to the setting before replacement.
30.
Execute the process control (SP3-011-001).
•
If you cannot execute SP5-824-001 or SP5-825-001 for some reason, try all the
following things.
- Check the changed SP value on the SMC which was output in step 2 and set it
manually. Especially, ensure that the values of the following SPs are same as the