16
NOTE
: The throws are measured at the widest part of the elevator, rudder and aileron. Adjust the position of the
pushrods at the control/servo horns to control the amount of throw. You may also use the ATV’s if your transmitter
has them but the mechanical linkages should still be set so that the ATV’s are near 100% for best servo resolution.
High rate
Low rate
ELEVATOR 1/2 “ ( 12mm) up
1/3” (7mm) up
1/2 “ ( 12mm) down
1/3” (7mm) down
RUDDER 1 “ (25mm) right
5/8” (13mm) right
1” (25mm) left
5/8” (13mm) left
AILERON 3/8” (11mm) up
1/4” (8mm) up
3/8” (11mm) down
1/4” (8mm) down.
Note: If your radio does not have dual rates, then set the control surfaces to move al the low rate throws.
33.1
Once you have confirmed that the CG is
correct, you should do a thorough review of the
entire model before your first flight. Check every-
thing twice! Every hook up, every coupling, every-
thing! Do it twice!!
33.2
Before your first flight , have an experienced
flyer review your work. Do not fly your model until
it has been checked out by a third party who
knows how to fly and how to set up a model air-
craft
33.3
Once you have completed your first flight,
get in the habit of checking your model over
before and after each flight! Don’t fly if you find
something that is not right!
Stage 33
CONFIRM MECHANICAL INTEGRITY
80 - 85 mm
3 1/8 - 3 3/8”
Elevator
Aileron
Rudder
5/8”
13mm
5/8”
13mm
1/4”
8mm
1/4”
8mm
1/3”
7mm
1/3”
7mm
CG
Parts for this VMAR Model
In the event that you require replacement parts for you VMAR FUJI FA200 - AERO SUBARU, you can order parts from your retail-
er or from the VMAR On - line store at www.richmondrc.com.
Fuselage
#VA.113L.046F (with servo tray & all rods)
Wing set
#VA.113L.046W (a set of left and right with joiner ect)
Tail set
#VA.113L.046T (contains horizontal and vertical stabilizers)
Cowl
#VA.113L.046L (fiberglass)
Canopy set
#VA.113L.046N (canopy and frame)
Main gear
#VA.113L.046MG (fiberglass main landing gear with axle set)
Wheel pant set
#VA.113L.046WH (with main gear fairing set)
Covering set
#VA.113L.046V (POLYCOTE ECS)
Wing parts bag
#VA.113L.046WP (spar joiner, aileron rods ect)
Master bag
#VA.113L.046MB (as in kit)
For aftermarket parts and other information related to this model see VMAR On - line at www.richmondrc.com.
