Stage 23
Stage 24
Stage 25
13
Connect the elevator servo to the receiver and turn on your transmitter. Confirm that the
neutral positions of the elevator servo are sustained as per illustration 22.3
22.2 Pre-installed elevator, throttle
and rudder pushrod
22.3 Connect clevises on pushrods to the servo arms first, then
install the servo arms to the servos
CONNECTING THE PUSHRODS TO THE ELEVATOR
23.1 Two independent elevator
control horns shown in position
23.2 Loose the collars to connect the elevator pushrods to the elevator
control horns, align the elevator surfaces, then tighten collars securely.
CONNECTING THE PUSHRODS TO THE RUDDER
Connect the rudder servo to the receiv-
er and turn on your transmitter. Confirm
that the neutral positions of the rudder
servo are sustained as per illustration
22.3
24.1 The rudder pushrod is connected to the rudder control horn
CONNECTING THE THROTTLE CONTROL
Connect the clevis to the engine throttle arm at roughly half throttle. Look
into the throat of the engine carburetor as you rotate the throttle arm and
select a position where the throttle opening is about haft what it is when
fully open.
25.1 Throttle control rod
Connected to the engine throttle arm
engine throttle arm
25.2 Throttle control rod connect-
ed to the engine throttle arm
Elevator pushrod
Throttle pushrod
Nose gear pushrod
Rudder pushrod
