Stage 19
Stage 20
11
19.1 Power module installed to
the fuselage
19.2 SUBARU cowl pre-cut and
decorated, suitable for VMAX .46
and VMAX.52
19.3 Install suitable Propeller and
spinner after finishing the cowl
installation.
18.2 Place the steering arm with pre-install EZ
connector to the nylon nose gear bearing
18.4 Insert the nose gear push rod to the EZ con-
nector
18.3 Slide the nose gear to the bearing, passing
through the steering arm. Secure the steering arm
to the nose gear by tighting the hex-nut to the
mark on the nose gear.
18.5 Typical nosegear installation
To the rudder servo
INSTALLING THE COWL
FITTING ELEVATOR AND RUDDER CONTROL HORN
The elevator control is fitted on the underside of both right and left
of the elevator halves. Pierce the covering over the pre-drilled hole
for the control horns installation as shown.
20.1 Control horn
