INSTALLATION MANUAL
EN
- Make sure that the cable is not crushed between the wall
and the cabinet.
- Never use extension cables that are not compatible with the
original connection system.
WARRANTY
- The warranty on the device is valid only if powered by a
power supply provided by DOMUS Line. The warranty's
general terms and conditions for this device are available at
www.domusline.com
- If more than one device must be connected to the power
supply ensure that the total sum of the power absorbed by
the devices (check the plate data shown on the product label)
does not exceed the maximum power permitted by the
Converter.
HOW THE TRACK + TRACK controller WORKS
Switching on and off takes place by simply approaching your
hand to the sensitive IR switch (E), keeping a steady hand in
front of it you can adjust the intensity of light. A short flash of
the light indicates the achievement of maximum brightness.
The luminosity level obtained will be saved until the next
adjustment.
The output cable of the
TRACK CONTROLLER
can handle a
load of max. 72W @ 24Vdc.
The luminaire is equipped with a safety program that
switches off
TRACK
after 18 hours of continuous operation.
ATTENTION
- If external flexible cable or cord of this luminaire is
damaged, it shall be replaced by a special cord or cord
exclusively avaible from the manufacturer or his service
agent.
- The LED module of these luminaires cannot be replaced.
- In the event of failure, the entire luminaire must be
replaced.
- Never run any cable through sharp corners and edges.
- If the cable needs to be secured use only insulated clips or
plastic cable ties.
